This is the gasket between the cast iron throttlebody and the floatbowl. They do not have vent slots. Factory used this gasket.
However, there are no problems using the gasket in this location with the vent slots.
This gasket is proc 1/16" thick andhas the vent slots, as almost all do. There is a lot of confusion about thses slots. They do not create a vacuum leask as they are above the throttleblades. They vent vapors that build up behind the throttle blades at hot idle.
Come in two sizes. Small for the 59 to 65 center carbs and the 57 and 58 carbs. The large size is for the 59 to 66 ends and the 66 center. You can choose size and number when you place items in the cart.
These gaskets are seldom in the carb kits others sell. They are included in the kits I sell on the page.
Often needed after removing airhorn to replace jets, set floats, or to replace a wet gasket. I have never seen this gasket sold separately. Top Quality. When you add to cart, you can specify which carb. Smaller center carb takes different gasket, of course.
Top Quality. Specify which carb and quantities as you place in cart.
Gasket between block off plate and intake.
Excellent reproduction of originals. If you need all three studs and all three wingnuts, this item is available on the page for a savings.
Correct bottleneck stud. Shorter than the stud for the small, GTO style air cleaners.
Attaches choke stove. Phillips head bolt same as original, with special washer, also SS. Factory bolt was steel and rusted with the heat in this area.
Excellent Reproduction Of OEM Part. If you need all three studs and three chrome eingnuts, this item is offered on the page at a savings. This set described is for the GTO style air cleaners.
